Agency Certifications; United States (Fcc); Oem Labeling Requirements; Fcc Notices - Digi XBee Product Manual

Agency certifications

United States (FCC)

XBee / XBee-PRO RF Modules comply with Part 15 of the FCC rules and regulations. Compliance with
the labeling requirements, FCC notices and antenna usage guidelines is required.
To fulfill FCC Certification requirements, the OEM must comply with the following regulations:
1. The system integrator must ensure that the text on the external label provided with this device is
placed on the outside of the final product.
2. XBee / XBee-PRO RF Modules may only be used with antennas that have been tested and
approved for use with this module (refer to the antenna tables in this section).

OEM labeling requirements

WARNING! The Original Equipment Manufacturer (OEM) must ensure that FCC labeling
Figure 29: Required FCC Label for OEM products containing the XBee / XBee-PRO RF Module
* The FCC ID for the XBee is "OUR-XBEE". The FCC ID for the XBee-PRO is "OUR-XBEEPRO".

FCC notices

IMPORTANT: The XBee / XBee-PRO RF Module has been certified by the FCC for use with other
products without any further certification (as per FCC section 2.1091). Modifications not expressly
approved by Digi could void the user's authority to operate the equipment.
IMPORTANT: OEMs must test final product to comply with unintentional radiators (FCC section
15.107 and 15.109) before declaring compliance of their final product to Part 15 of the FCC Rules.
IMPORTANT: The RF module has been certified for remote and base radio applications. If the module
will be used for portable applications, please take note of the following instructions:
XBee / XBee-PRO RF Modules 802.15.4 Product Manual
requirements are met. This includes a clearly visible label on the outside of the final
product enclosure that displays the contents shown in the figure below.
Contains FCC ID: OUR-XBEE/OUR-XBEEPRO**
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any inter-
ference received, including interference that may cause undesired operation.
98