AT commands
TR (Transmit Error Count)
Parameter range
0 - 0xFFFF
Default
0
UA (Unicasts Attempted Count)
The number of unicast transmissions expecting an acknowledgment (when RR > 0).
This value is volatile (the value does not persist in the device's memory after a power-up sequence).
Parameter range
0 - 0xFFFF
Default
0
Firmware commands
The following AT commands are firmware commands.
CK (Configuration CRC)
Displays the cyclic redundancy check (CRC) of the current AT command configuration settings.
This command allows you to detect an unexpected configuration change on a device. Use the code
that the device returns to determine if a node has the configuration you want.
After a firmware update this command may return a different value.
Parameter range
N/A
Default
N/A
DD (Device Type Identifier)
Stores the Digi device type identifier value. Use this value to differentiate between multiple XBee
devices.
If you change DD,
default values is to explicitly set it to defaults.
Parameter range
0 - 0xFFFFFFFF
Default
0x80000
XBee®/XBee-PRO XTend Compatible (XTC) DigiMesh RF Module User Guide
RE (Restore Defaults)
will not restore defaults. The only way to get DD back to
Firmware commands
45