In-Field Operation
IMPORTANT
Ensure that Main Frame Lift SCV and Wing Fold SCV are
placed in the FLOAT POSITION
the machine in field to prevent damage to cylinders.
IMPORTANT
Never use Main Frame Lift SCV during headland turns.
Fig. # 4-55 Do Not Use Main Frame Lift SCV To Raise Rear
Sections During Headland Passes
●
For lifting the tool on pass to pass turns, use Front
Wheels SCV and Rear Roller SCV to raise the tool to
the Field Raised Position.
Fig. # 4-56 "Field Raised Position"
●
For turning, using skip passes is recommended with the
tool in the ground and operating speeds of 7 mph (11
km/h).
4 - WORKING OPERATIONS
before operating
DO NOT
Raise Using
Main Lift SCV
While Moving
(See Fig. # 4-56)
A
B
For backing up the tool, always raise Front Wheels SCV
●
and Rear Roller SCV.
Fig. # 4-57 "Field Raised Position"
●
For backing up the tool with the rubber roller option,
retract the Optional Equipment SCV which is the SCV
for Rubber Roller Scrapers.
Fig. # 4-58 Retract The Rubber Roller Scraper Cylinders
●
Adjust machine to a depth of 2 in - 3 in (51 mm - 76 mm)
in spring and 3.5 in - 4.5 in (89 mm - 114 mm) in fall.
●
Adjust operating speed to 10.5 mph - 11.5 mph (17 km/h
- 18.5 km/h) for best performance.
●
When the rubber roller option is used, and the Rubber
Roller Scrapers are not being used, retract the Optional
Equipment SCV which is the SCV for Rubber Roller
Scrapers.
●
Operate the tillage in the field at a 8-10 degree angle from
the previous planted crop to reduce wear on the machine.
4-21
A
B