Check Disk Hubs For Excessive Wear - Norwood Kwik-Till HSD2500 Operator's Manual

ANNUALLY

Check Disk Hubs For Excessive Wear

1. Fold the machine into the Transport Position.
"Kwik-Till Folding & Unfolding" on page 4-11)
WARNING
When servicing the machine in the transport position, the
wings must be secured with the transport locks.
2. Make sure the Transport Locks
the Stowed Position
B
Position .
(See Fig. # 5-28)
A
D
C
Fig. # 5-33 Transports Lock Shown In Locked Position
3. Check all Disk Hubs
B
4. Rotate Disks CW (Clockwise) and CCW (Count-
er-Clockwise) to check for bearing roughness.
# 5-34)
B
Fig. # 5-34 Check For Bearing Roughness
5. If bearings sound or feel rough, replace the hub.
A
are moved from
C
, and installed into the Locked
B A
A
on the machine.
(See Fig. # 5-34)
A
5 - MAINTENANCE
The Disk Hubs
placed as a unit.
(See
6. Remove the Disk Hub Nut
from the Shank
Fig. # 5-35 Remove Disk Assembly From Shank
7. Support the Disk Assembly
(Qty. 2) 6" X 6" X 8" Wood Spacers
5-36)
F
(See Fig.
Fig. # 5-36 Support The Disk Assembly To Remove The
5-27
IMPORTANT
H
are not serviceable, and must be re-
C
and Disk Assembly
E
. (See Fig. # 5-35)
D E C
D
on a sturdy surface with
D
Hub
D
F
.
(See Fig. #
F