Preparing Kwik-Till; Drawbar Requirements - Norwood Kwik-Till HSD2500 Operator's Manual

Preparing Kwik-Till

Drawbar Requirements

IMPORTANT
Tractor drawbars must be compatible with the Kwik-
Till hitch links or damage to machine and/or tractor
can occur. Refer to the tractor Operator's Manual for
specific drawbar requirements. For ordering hitch
links see your Kwik-Till dealer, for hitch pins, see your
tractor dealer or qualified service provider. Do not
exceed static vertical load capacity of tractor drawbar.
See Specifications section
Tractor Drawbar" on page 7-1)
see tractor operator's manual for drawbar limits and
heavy-duty supports.
Fig. # 3-8 Determining Drawbar Hitch Link Size
Hitch
Hitch Pin
Category
Diameter (A)
2.0 in
4
(51 mm)
2.75 in
5
(71 mm)
Fig. # 3-9 Table: Determining Drawbar Hitch Link Size
(Non-Articulating Ball)
3 - TRANSPORT OPERATIONS
(See "Downward Force on
for vertical load and
A
Tractor Drawbar
Drawbar Opening
Height (B)
3.54 in
(90 mm)
3.94 in
(100 mm)
Cat. 4 Hitch Link
(Max. Hitch Pin
2" (51 mm) Dia. )
P/N 90-42-0012
Fig. # 3-10 Cat. 4 Hitch Link, Non Articulat-
ing Ball, Standard For HSD2500, & HSD3000
(Max Dia. Hitch Pin Ø2.0 (51 mm))
B
Cat. 5 Hitch Link
(Min. Hitch Pin Dia.
2" (51 mm))
(Max. Hitch Pin Dia.
2-3/4" (71 mm))
P/N 90-42-0026
Fig. # 3-11 Cat. 5 Hitch Link, Non Articulating Ball, Stan-
dard For HSD3500, HSD4000, & HSD4500 (Min. Hitch Pin
Dia. Ø2.0" (51 mm)) (Max. Hitch Pin Dia. Ø2.75" (71 mm))
3-5
P/N 90-42-0026