FIELD OPERATION
Before Entering Field Guidelines
1.
Read the Operator's Manual before operating.
2.
Check all lubrication points and grease as instruct-
ed in the maintenance section.
NANCE" on page 5-1)
3.
Use recommended size tractor.
Power Requirements" on page 7-1)
4.
Be sure that tractor and machine have been properly
prepared. Check that the unit is properly attached
to the tractor. On pull-type unit, be sure there is a
mechanical retainer through the draw-bar pin and the
safety chain is installed.
Tractor" on page 3-9)
5.
Check tire pressure.
page 7-3)
6.
Inspect all hydraulic lines, hoses, couplers, and
fittings. Tighten, repair, or replace any leaking or
damaged components.
7.
Inspect, or torque all specified hardware.
MAINTENANCE" on page 5-1)
8.
Fully charge hydraulic system.
Tighten Hardware
10
50
350 ft-lbs
Check tightness of all bolts after first 10 hours of then every
50 hours thereafter. Tighten all bolts to torques specified in
475 N-m
the Maintenance Section unless otherwise noted.
MAINTENANCE" on page 5-1)
4 - WORKING OPERATIONS
(See "5.0 MAINTE-
(See"Tractor Engine
(See "Attaching Kwik-Till To
(See"Tire Specifications" on
(See "5.0
(See "5.0
Leveling the Hitch
The Kwik-Till must be parallel to the ground when the Kwik-
Till is operating in the field. A level hitch will reduce issues
in the field.
Attach the Kwik-Till to the tractor. Set tractor hitch sway limit-
ers for 'No Sway' operation. Check the tractor and Kwik-Till
for correct tire pressure and adjust as necessary.
1. Lower the Kwik-Till to the Field Lowered Position, by fully
retracting the Rear Roller
B
. The cylinders will bottom out on the Depth Stops
, and the disks will engage the soil at the set depth.
Fig. # 4-49)
Fig. # 4-49 Field Lowered Position
2. If the hitch is not level as shown
, then adjust the Hitch Link position on the
Fig. # 4-51)
hitch tongue.
(See Fig. # 4-52)
following pages to adjust the clevis.
Fig. # 4-50 Kwik-Till Not Level - Raise Hitch Link (Down-
4-18
A
and Front Wheel Cylinders
(See Fig. # 4-50)
&
(See Fig. # 4-53)
Raise
Hitch
Link
Front Of Hitch
Too High
ward Angle)
C
(See
&
(See
on the