Attaching Kwik-Till To Tractor - Norwood Kwik-Till HSD2500 Operator's Manual

Attaching Kwik-Till To Tractor

1. Clear the area of bystanders and remove foreign objects
from the Kwik-Till and working area.
2. Make sure there is enough room to back the tractor up
to the Kwik-Till hitch.
3. Start the tractor and slowly back it up to the align the hitch
point.
(See Fig. # 3-19)
Fig. # 3-19 Back Tractor To Align Hitch Point
WARNING
Before connecting equipment, servicing, adjusting, or
repairing :
Park on a level surface, engage park brake, place
transmission in PARK, shut off engine, remove key, and wait
for all moving parts to stop before leaving the tractor cab.
WARNING
Avoid hazards due to escaping fluid under pressure.
See the Hydraulic Safety section in this manual. Hydraulic
hoses can fail due to physical damage, kinks, age, and
exposure. Check hoses regularly. Replace damaged hoses.
IMPORTANT
All hydraulic couplers must be clear of debris, dust, and
sand. Foreign material can damage hydraulic system.
3 - TRANSPORT OPERATIONS
4. Locate the "Hitch Jack Hydraulic Hoses" B attached
to the "Hitch Jack" A .
RED HOSE
GRIP (+)
Fig. # 3-20 Locate The Hitch Jack Hydraulic Hoses
5. Make sure that the Hitch Jack hydraulic hose ball valve
is in the "CLOSED" position.
CLOSED
Fig. # 3-21 Make Sure The Ball Valve Is "CLOSED"
3-9
(See Fig. # 3-20)
RED HOSE
GRIP (-)
(See Fig. # 3-21)
(Shown in the "CLOSED" Position)
A
B