Pre-Operation Checklist - Norwood Kwik-Till HSD2500 Operator's Manual

PRE-OPERATION CHECKLIST

(OWNER'S RESPONSIBILITY)
Efficient and safe operation of the Kwik-Till requires that each
operator reads and understands the operating procedures and
all related safety precautions outlined in this section.
A pre-operation checklist is provided for the operator. It is
important for both the personal safety and maintaining the
good mechanical condition of the Kwik-Till that this checklist
is followed.
Before operating the Kwik-Till and each time thereafter, the
following areas should be checked off:
1. Read the Operator's Manual before operating.
2. Check all lubrication points and grease as instruct-
ed in the maintenance section.
NANCE" on page 5-1)
3. Use recommended size tractor.
requirements are shown in the following" on page
7-1)
4. Be sure that tractor and machine have been properly
prepared. Check that the unit is properly attached
to the tractor. On pull-type unit, be sure there is a
mechanical retainer through the draw-bar pin and the
safety chain is installed.
Tractor" on page 3-9)
5. Check tire pressure.
page 7-3)
6. Inspect all hydraulic lines, hoses, couplers, and
fittings. Tighten, repair, or replace any leaking or
damaged components.
7. Inspect, or torque all specified hardware.
MAINTENANCE" on page 5-1)
8. Fully charge hydraulic system.
4 - WORKING OPERATIONS
(See "5.0 MAINTE-
(See "Tractor power
(See "Attaching Kwik-Till To
(See"Tire Specifications" on
(See "5.0
4-5