Repack Wheel Bearings - Norwood Kwik-Till HSD2500 Operator's Manual

AS REQUIRED

Repack Wheel Bearings

A grease change in hub bearings is recommended Every
3,000 working hours or every 3,107 mi (50,000 km)
traveled).
1. Unfold the machine into the Field Position.
Till Folding & Unfolding" on page 4-11)
2. Lower the Kwik-Till to the Field Lowered Position, by fully
retracting the Rear Roller
B
. The cylinders will bottom out on the Depth Stops
C
, and the disks will lower to the floor raising the wheels
and rear roller.
(See Fig. # 5-31)
Fig. # 5-49 Field Lowered Position For Service
3. All 4 wheels should now be raised off the ground.
4. Remove the Wheel Flange Nuts
Fig. # 5-50)
A
Fig. # 5-50 Remove Wheel Flange Nuts & Wheel
5 - MAINTENANCE
(See "Kwik-
A
and Front Wheel Cylinders
A
and the Wheel.
B
5. Remove (Qty. 4) 3/8"-24 X 3/4 Socket Bolts
C
Dust Cap
# 5-51)
G
C
Fig. # 5-51 Remove Socket Bolts & Dust Cap
6. Remove 1/4"X 2-1/2" Cotter Pin
Slotted Nut
(See
F
E
Fig. # 5-52 Remove Cotter Pin & Slotted Nut
5-33
, and the Dust Cap Gasket
D
E
F
.
(See Fig. # 5-52)
D
, the
G
.
(See Fig.
, & the 1-1/4"-12