3.0 Transport Operations - Norwood Kwik-Till HSD2500 Operator's Manual

3.0 TRANSPORT OPERATIONS

Transport Safety
IMPORTANT
Transport the machine at a reasonable and safe
speed, which permits adequate control of steering and
stopping. Reduce speed considerably when traveling
over rough ground. Be certain everyone is clear of
machine.
1. Read and understand ALL the information in the Oper-
ator's Manual regarding procedures and SAFETY when
moving or transporting the machine.
2. Check with local authorities regarding transporting on
public roads. Obey all applicable laws and regulations.
3. Always travel at a safe speed. Use caution when making
corners or meeting traffic. Travel speed should be such
that complete control and machine stability is maintained
at all times.
4. Make sure the SMV (Slow Moving Vehicle) emblem and
all the lights and reflectors that are required by the local
highway and transport authorities are in place, are clean
and can be seen clearly by all overtaking and oncoming
traffic.
5. Do not allow riders on the Kwik-Till or the tractor.
6. Attach Kwik-Till hitch link to tractor drawbar, verify that the
hitch pin and retainer is used. Always attach the safety
chain.
7. Keep to the right and yield the right-of-way to allow faster
traffic to pass. Drive on the road shoulder, if permitted by
law.
8. Do not exceed the maximum transport speed for this
implement of 20 mph (32 km/h). Reduce speed on rough
roads and surfaces.
9. Stay away from overhead obstructions and power lines
when transporting. Electrocution can occur without direct
contact. Contact local authorities or utilities to obtain
safe clearance distances from high voltage power lines.
Should a contact between the machine and an electric
power source occur, the following precautions must be
taken: Stop the machine movement immediately. Apply
the park brake, stop the engine. Check if you can safely
leave the cab or your actual position without contacting
the electrical wires. If not, stay in your position and call
for help. If you can leave your position without touching
lines, jump clear of the machine to make sure you do not
3 - TRANSPORT OPERATIONS
make contact with the ground and the machine at the
same time. Do not permit anyone to touch the machine
until power has been shut off to the power lines.
10. Always use hazard warning flashers on tractor & Kwik-Till
when transporting unless prohibited by law.
11. Slow down and signal before turning.
12. Follow correct towing procedure for equipment without
brakes.
13. To improve stability when traveling through the field, wings
should be unfolded from transport position as soon as
possible after leaving the roadway.
14. Towed loads can swerve, upset, or cause loss of control.
Refer to Tow Loads Safely in this section.
3-1
Fig. # 3-1 Transport Hazard Area
OVERHEAD
WIRES
KEEP AWAY
KEEP OUT
OF SHADED
HAZARD
AREA
CRUSH
HAZARD
BETWEEN
TRACTOR &
IMPLEMENT
KEEP OUT