Scraper Blade Replacement & Alignment - Norwood Kwik-Till HSD2500 Operator's Manual

5. Once the gap is set, adjust the 7/16" Set Screws A
against the Adjustable Scraper Ears B .
5-20)
Fig. # 5-20 Tighten Set Screws
6. Tighten the (Qty 8) 1/2"-13 Nylock Nuts A .
5-21)
Fig. # 5-21 Tighten Hardware
5 - MAINTENANCE
(See Fig. #
A
B
A
(See Fig. #
A
5-12
Scraper Blade Replacement & Alignment
The following instructions are for the purpose of replacement
and alignment of the scraper blades of the Kwik-Till tillage
equipment rubber roller option. To start, proceed as follows:
1. Unfold the machine into the Field Position.
Folding & Unfolding" on page 4-11)
2. Lower the disks to the ground by retracting the Front
Wheel Cylinders A and Rear Roller Cylinders B .
Fig. # 5-22)
Fig. # 5-22 Lower Disks to the Ground
3. Relieve all the hydraulic pressure by placing the tractor
SCV levers to the FLOAT POSITION
running for the Main Frame Lift & Wing Fold cylinders.
(See Fig. # 5-23)
Fig. # 5-23 Tractor Remote Valve Levers Setting SCV To
Float Position
(See "Kwik-Till
A
B
with engine
(See