•
Adjust operating speed to 10.5 mph - 11.5 mph (17 km/h
- 18.5 km/h) for best performance.
•
Adjusting the Front Disk Height
removing Depth Stops
C
Cylinders
, and the two Wing Strut Cylinders
(See Fig. # 4-14)
Fig. # 4-14 Adjusting The Front Disk Height
Adjusting the Rear Disk Height
•
removing Depth Stops
C
inders
.
(See Fig. # 4-15)
Fig. # 4-15 Adjusting The Front Disk Height
4 - WORKING OPERATIONS
A
is done by adding/
B
to the two Center Strut Wheel
A
is done by adding/
B
to the four Rear Roller Cyl-
Understanding Depth Control Components
Before disconnecting equipment, servicing, adjusting,
C
.
:
or repairing
Park on a level surface, engage park brake, place
transmission in PARK, shut off engine, remove key, and wait
for all moving parts to stop before leaving the tractor cab.
•
To set the Depth Stops
B
the Hitch Pin
B
Fig. # 4-16 Adjusting The Depth Stops Step # 1
•
Engage the required amount of Depth Stops
grees towards the Cylinder Rod
C
starting from the Cylinder Stop Plate
Fig. # 4-17)
Failure to add or remove depth stops from the wrong
end of the hydraulic cylinder will cause hydraulic cylinder
component and hydraulic cylinder damage.
(See Fig. # 4-10)
Fig. # 4-17 Adjusting The Depth Stops Step # 2
4-8
WARNING
C
, remove the Hair Pin
.
(See Fig. # 4-16)
C
E
. Add Depth Stops
IMPORTANT
(See Fig. # 4-9)
C
B
D
E
A
, and
A
C
, 90 De-
D
only.
(See
A