Transport Locks - Norwood Kwik-Till HSD2500 Operator's Manual

6. Check the Penetration Depth
A
& the Rear Row Disks
you would like to raise or lower both the front and rear
disk rows - round to the nearest 1/2".
Fig. # 4-22 Check the Penetration Depth
7. If you are satisfied with this setting proceed with field
operation, if not proceed to step # 8.
8. Repeat steps # 4 thru. # 7 until the proper depth is
achieved.

Transport Locks

The Kwik-Till has two Transport Locks
locked to the hitch during transport, service and storage. The
transport locks are located on the left and right Transport
D
Rests . The transport locks MUST be installed on the
transport rests securing the wings in the Locked Position
B
whenever the Kwik-Till is transported, serviced, or stored
to avoid the wings breaking free from the transport rests.
The transport locks have a designated Stowed Position
on the transport rests. The transport locks MUST be returned
in the Stowed Position before the Kwik-Till is unfolded.
• Remove the Transport Locks
B
sition and install into the Stowed Position
unfolding.
(See Fig. # 4-23)
A
D
C
Fig. # 4-23 Transports Lock Shown In Locked Position
4 - WORKING OPERATIONS
D
of the Front Row Disks
B
. Take note of how much
(See Fig. # 4-22)
A
to keep the wings
A
from the Locked Po-
C
when
B A
• Remove the Transport Locks
C
sition and install into the Locked Position
transport, service and storage.
B
A
D
Fig. # 4-24 Transports Lock Shown In Stowed Position
C
4-10
A
from the Stowed Po-
(See Fig. # 4-24)
C B A
B
before