Check Wheel Bearings - Norwood Kwik-Till HSD2500 Operator's Manual

ANNUALLY

Check Wheel Bearings

1. Unfold the machine into the Field Position.
Till Folding & Unfolding" on page 4-11)
2. Lower the Kwik-Till to the Field Lowered Position, by fully
retracting the Rear Roller
B
. The cylinders will bottom out on the Depth Stops
C
, and the disks will lower to the floor raising the wheels
and rear roller.
(See Fig. # 5-31)
Fig. # 5-31 Field Lowered Position For Service
3. All 4 wheels should now be raised off the ground.
4. Check for bearing endplay by moving wheel side to side.
(See Fig. # 5-32)
5. Rotate wheel to check for bearing roughness.
# 5-32)
Fig. # 5-32 Check For Bearing Endplay Roughness
5 - MAINTENANCE
(See "Kwik-
A
and Front Wheel Cylinders
(See Fig.
6. If endplay exists, the bearings could be out of adjustment
of worn.
(See "Repack Wheel Bearings" on page 5-33)
7. If bearings sound or feel rough.
Bearings" on page 5-33)
5-26
(See "Repack Wheel