Kwik-Till Folding - Norwood Kwik-Till HSD2500 Operator's Manual

Kwik-Till Folding

1. If the Kwik-Till is already attached to the tractor, proceed
to step # 2, if not already attached to the tractor.
"Attaching and Detaching Kwik-Till To/From Tractor" on
page 3-8)
2. Transport the Kwik-Till onto level ground.
WARNING
Before disconnecting equipment, servicing, adjusting,
:
or repairing
Park on a level surface, engage park brake, place
transmission in PARK, shut off engine, remove key, and wait
for all moving parts to stop before leaving the tractor cab.
3. If the Kwik-Till is in the "Field Raised Position"
, proceed to step # 5, if not proceed to the next
# 4-37)
step.
Fig. # 4-37 "Field Raised Position"
4. Start the tractor and set to high idle, position the Kwik-
Till into the "Field Raised Position" make sure that the
A
Rear Roller and Front Wheel Cylinders
extended. When these cylinders are extended, the disks
will be completely off the ground.
Fig. # 4-38 "Field Raised Position"
4 - WORKING OPERATIONS
(See Fig. # 4-25)
B
(See Fig. # 4-38)
A B
If transport width is an issue, retract the rear roller cylinders
and place 9 depth stops down. This will make the transport
(See
width narrower, but will increase the transport height.
5. Remove the Main Frame Lift & Wing Fold cylinders from
FLOAT POSITION
(See Fig.
Fig. # 4-39 Tractor Remote Valve Levers Removing SCV
6. Use the tractor remote valve lever to retract the Main
Frame Lift
Left Wing
Fig. # 4-40)
D
are fully
Fig. # 4-40 Fold Step # 1 - Raising Rear Sections (Field
4-15
IMPORTANT
.
(See Fig. # 4-39)
From Float Position
A
cylinders to raise Center Section
C D
, & Right Wing from the ground.
C
B
A
Raised Position Shown)
B
,
(See
A