Check For Gap At Pivot Bushing Caps - Norwood Kwik-Till HSD2500 Operator's Manual

WEEKLY

Check For Gap At Pivot Bushing Caps

1. Unfold the machine into the Field Position.
Till Folding & Unfolding" on page 4-11)
2. Lower the disks to the ground by retracting the Front
Wheel Cylinders A and Rear Roller Cylinders B .
(See Fig. # 5-10)
Fig. # 5-10 Lower Disks to the Ground
3. Relieve all the hydraulic pressure by placing the tractor
SCV levers to the FLOAT POSITION
running for the Main Frame Lift & Wing Fold cylinders.
4. The machine should now be in the "Field Lowered Po-
sition"
(See Fig. # 3-53)
5. Check Pivot Bushing Caps C for gaps E .
# 5-11)
CHECK FOR GAPS
E
(SHOULD BE FLUSH)
C
Fig. # 5-11 Check For Gaps At Pivot Bushing Caps
6. For Pivot Bushing Cap C locations,
(See "Kwik-
A
B
with engine
.
(See Fig.
(See Fig. # 5-9).
5 - MAINTENANCE
Any indication of any Gap E between Pivot Bushing
Caps C will cause bolt breakage and further machine
damage could occur due to uncontrolled machine move-
.
ment
7. If any Pivot Bushing Caps C have Gaps E , re-torque
the 3/4-10 X 3-3/4 Hex Bolts B to 500 ft-lbs (678 N-m).
(See Fig. # 5-12)
500 ft-lbs
678 N-m
Fig. # 5-12 Re-Torque All Pivot Bushing Caps With Gaps
5-19
IMPORTANT
E
E
B B
C C
B B