Replace Pivot Bushings - Norwood Kwik-Till HSD2500 Operator's Manual

AS REQUIRED

Replace Pivot Bushings

1. Unfold the machine into the Field Position.
Till Folding & Unfolding" on page 4-11)
2. Lower the disks to the ground by retracting the Front
Wheel Cylinders A and Rear Roller Cylinders B .
(See Fig. # 5-46)
Fig. # 5-46 Lower Disks to the Ground
3. Relieve all the hydraulic pressure by placing the tractor
SCV levers to the FLOAT POSITION
running for the Main Frame Lift & Wing Fold cylinders.
4. The machine should now be in the "Field Lowered Po-
sition"
(See Fig. # 3-53)
A
A A
(See "Kwik-
A
B
with engine
.
A
A
A
A
Fig. # 5-48 Pivot Bushing Component Locations
5 - MAINTENANCE
5. Remove (Qty. 2) 3/4-10 X 3-3/4 Hex Bolts B , (Qty. 2)
3/4 Washers D , and the Pivot Bushing Cap C , and
remove old Pivot Bushings A .
6. Install new pivot bushing and re-assemble in reverse order using
new hardware.
7. Tighten cap screws to specification.
ITEM PART NUMBER
A 55-4-00691
B 90-10-2847
C 55-4-00700
D 90-14-9016
Fig. # 5-47 Pivot Cap/Bushing Components
A A A A
A A
5-32
500 ft-lbs
678 N-m
DESCRIPTION
Pivot Bushing
Bolt, Hex 3/4-10 X 3-3/4 GR8 ZP W/TL Patch
Pivot Cap 4"
Washer, Flat 3/4 CZ
A
A
A A
A
C
D
B
A
A