Adjusting Soil Deflector - Norwood Kwik-Till HSD2500 Operator's Manual

Adjusting Soil Deflector

For spring tillage, set the soil Soil Deflector
ward as possible to allow residue to pass without causing
ridging. If a furrow is noticed, adjust the operating speed to
10.5 mph (17 km/h) and adjust the Soil Deflector
C
the Rear Shank Tube
1. To adjust the soil deflector
(Qty. 4) 1/2" Nylock Nuts
Fig. # 4-62 Adjusting The Soil Deflector Forward or Rear-
To prevent furrowing, avoid running the soil deflector
too deep into the soil.
2. To adjust the soil deflector
adjust up or down. The soil deflector has 5 height settings.
(See Fig. # 4-63)
A
Fig. # 4-63 Adjusting The Soil Deflector Up Or Down
4 - WORKING OPERATIONS
A
as far rear-
A
.
A
forward or rearward, loosen
D
.
(See Fig. # 4-62)
D A C
ward
NOTE
A
depth, remove pin
B
For fall or heavy residue tillage, place the soil deflector in
the storage position.
3. To disengage the soil deflector, remove it and place it into
towards
the storage position.
STORAGE
POSITION
Fig. # 4-64 Placing The Soil Deflector Into The Storage
A
B
and
4-23
NOTE
(See Fig. # 4-64)
A
Position.