Daily; Checking / Adjusting Scraper Alignment - Norwood Kwik-Till HSD2500 Operator's Manual

DAILY

Checking / Adjusting Scraper Alignment

1. Fully extend the scraper hydraulic cylinders.
5-16)
Fig. # 5-16 Fully Extend Scraper Hydraulic Cylinders
2. With the hydraulic cylinders fully extended, check the gap
between the scraper plates and the tire valley's. Desired
Gap is 3/8".
(See Fig. # 5-17)
for illustrative purposes)
Fig. # 5-17 Check Gap
5 - MAINTENANCE
(See Fig. #
(Note: Shank is removed
3/8" Gap
3. Check to see if the Shank Scraper Assemblies A are
centered in the valley of the Rubber Tires B .
# 5-18)
B
Fig. # 5-18 Center Scraper Assemblies
4. If the shank scraper assemblies are not centered, loosen
the 1/2-13 X 1-1/2 Bolts A securing the Scraper Base
Pivot Weldments B . Adjust left or right until centered.
(See Fig. # 5-19)
A
B
Fig. # 5-19 Adjusting Alignment
5-11
(See Fig.
B
A
A