Check Disk Shank Cord Alignment; Adjusting Disk Shank Cords - Norwood Kwik-Till HSD2500 Operator's Manual

MONTHLY

Check Disk Shank Cord Alignment

1. Fold the machine into the Transport Position.
"Kwik-Till Folding & Unfolding" on page 4-11)
WARNING
When servicing the machine in the transport position, the
wings must be secured with the transport locks.
2. Make sure the Transport Locks
the Stowed Position
B
Position .
(See Fig. # 5-18)
A
D
C
Fig. # 5-18 Transports Lock Shown In Locked Position
3. Check Disk Shank Cord
Shank)
(See Fig. # 5-19)
E
4. The Cords should not extend more than 3/4" from the
F
Tube Caps .
(See Fig. # 5-19)
Fig. # 5-19 Check Disk Shank Cord Alignment
5 - MAINTENANCE
A
are moved from
C
, and installed into the Locked
B A
E
alignment. (Qty. 4 Per Disk
F
E
5. If Cords extend greater then 3/4" from the Tube Caps
F
, the Cords
(See
Fig. # 5-20 Check Disk Shank Cord Alignment

Adjusting Disk Shank Cords

1. Loosen (Qty. 4) 5/8" Nylock Nuts
Nylock Nuts enough to allow movement of Disk Shank
E
Cords . Do not completely loosen the Nylock Nuts.
(See Fig. # 5-21)
G
E
Fig. # 5-21 Loosen (Qty. 4) 5/8" Nylock Nuts
5-22
E
should be readjusted.
F
3/4 in
(1.58 mm)
G
. Only loosen the
E
E
G