Check Tightness Of All Bolts, & Cap Screws - Norwood Kwik-Till HSD2500 Operator's Manual

WEEKLY
Check Tightness Of All Bolts, & Cap Screws
1. Unfold the machine into the Field Position.
Till Folding & Unfolding" on page 4-11)
2. Lower the disks to the ground by retracting the Front
Wheel Cylinders A and Rear Roller Cylinders B .
(See Fig. # 5-4)
Fig. # 5-4 Lower Disks to the Ground
3. Relieve all the hydraulic pressure by placing the tractor
SCV levers to the FLOAT POSITION
running for the Main Frame Lift & Wing Fold cylinders.
4. The machine should now be in the "Field Lowered Po-
sition"
(See Fig. # 3-53)
5. Check tightness of all bolts, & cap screws.
10
50
350 ft-lbs
6. Use the torque charts at the back of this manual for proper
torque, unless otherwise specified in this manual.
475 N-m
"Torque – Fasteners" on page 7-5)
(See "Kwik-
A
B
with engine
.
5 - MAINTENANCE
(See
5-16