Cleaning The Ro Cartridge(S) - Millipore Milli-Q Direct 8 System User Manual

Cleaning the RO Cartridge(s)

Cleaning the RO cartridge may be required when feed water contains excess
When
of some chemicals.
Pe rform
Ser vic
Wear Eye Safety Glasses and Laborator
!
equipment when cleaning the RO Cartridge(s).
Safety
Follow the steps below to clean the RO Cartridg
Cleaning
Step
cleaning if required, after recommend
e R epresentative.
Action
1 Open the sa nitisation port as
described in the previous
section.
2 Place a cleaning agent pouch
(ROClean A or ROClean B)
into the Sanitisation Port.
3 Put the cap back on and hand-
tighten it.
NOTE:
The chemical in the pouch will
dissolve during the pH
Cleaning sequence. Remove
the empty pouch the next time
the Santisation Port cap is
removed.
4 Go to STANDBY Mode.
ation from
y Gloves and other appropriate safety
e(s).
- 89 -
your Mil lipore
Diagram
Continued on next page