Calibrating The Flow Rate - Millipore Milli-Q Direct 8 System User Manual

Calibrating the Flow rate

T he Milli-Q Water flow rate should be calibra
Introduction
in stalled
A 1 Litre graduated
Follow the steps below to perform
Procedure
Step
.
cy linder is needed.
Action
1 Go to STANDBY Mode.
2 Select Menu.
Press .
3 Enter the Manager Menu.
See the Software Chapter to
learn how to enter the Manager
Menu.
4 Select Setup.
Press .
5 Select Flow Calibration.
Press .
ted when the System is
a Flow Calibration.
- 42 -
Diagram
Continued on next page