Millipore Milli-Q Direct 8 System User Manual page 78

Replacing the Q-Pak Pack,
Removing
(continued)
Step
Follow the steps below to install a new Q-Pak Pack.
Placing
Step
Continued
Action
4 Remove the used Q-Pak Pack.
5 The System will indicate that
the Q-Pak Pack is removed in a
few moments.
Action
1 Remove the covers on the 2
ports of the Q-Pak Pack.
Look inside the ports.
Make sure the rubber O-rings
are firmly in place.
Wet the O-rings with water.
2 Push the top of the Q-Pak Pack
into th e p ort s on the System.
Push on the bottom of the
Q-Pak Pack.
- 78 -
Diagram
Diagram
Continued on next page