Replacing A Pod Pak - Millipore Milli-Q Direct 8 System User Manual

Replacing a POD Pak

O ne possible reason for a decrease in
Basing o n flow
POD Pak. The POD Pak should be replaced when it appears to be clogged.
rate
For
locked. Dispense water and open the vent to s
Close the
The POD Pak needs replacement when the follo
Basing on LCD
displayed.
message
 Alert message = REPLACE POD PAK
Follow the instructions delivered with the POD Pak.
Placing and
flushing
The
Registering
Fol low
Step
M illip ak and BioPak final filters, make
vent after this.
PO D Pak installation has to be reg
the steps below to register the inst
Action
1 Start in TA S NDBY Mode.
2 Select Menu.
Press .
3 Select M aintenance.
Press .
Milli-Q Water flow rate is a clogged
sure th
ee if there is any trapped air.
wing Alert message is
istered.
allation of
- 81 -
e POD Pak is not air-
the POD Pak.
Diagram
Continued on next page