Replacing The Q-Pak Pack - Millipore Milli-Q Direct 8 System User Manual

Replacing the Q-Pak Pack

The Q-Pak Pack should be replaced when one of the following Alarm or Alert
When
m essages is displayed.

Alarm
 Alert me
Remove the used Q-Pak Pack by following the steps below.
Removing
Step
message = MILLI-Q RES < SP, REPLAC
ssage = REPLACE Q-P
Action
1 Place the system into
STANDBY Mode.
2 Push the POD Plunger down
once to depressurise the
System.
After water stops being
dispensed, push down the
POD Plunger again.
3 Open the System left door.
Lift up the Pack Locking
Handle.
AK PACK
- 77 -
E Q-PAK
Diagram
Continued on next page