Disassembly Procedures; Removing The Upper Case; Removing The Control Panel - Epson Stylus Photo 870 Service Manual

EPSON Stylus Photo 870/1270
Table 4-3. Screw Characteristics
Screw number Illustration
7
8
9

4.2 Disassembly Procedures

4.2.1 Removing the Upper Case

1. Remove the paper support.
2. Open the output tray and lift up the printer cover.
3. Set the paper thickness lever to the + position.
4. Remove the two No.8 screws securing the front of the upper
case, as shown in Figure 4-1. Then remove the two No.8 screws in
the deep holes at the rear of the case.
5. Lift off the upper case.
No.8 screws
Figure 4-1. Removing the Upper Case
Name Size
×
+Bind, S-tight, M3 6
Sems
R2(CBS Sems)
×
+Bind, S-tight, M3 10
×
+Pan head, B-tite 1.7 5
Sems W1
No.8 screws
Chapter 4 Disassembly and Assembly

4.2.2 Removing the Control Panel

Preparation:
! Remove the upper case (see the previous section).
1. If necessary (to access the control panel screws in the next step),
push the carriage lock lever down beneath the metal plate, as
shown below. Then slide the carriage to the middle.
Figure 4-2. Releasing the Carriage Lock
2. Remove the two No.1 screws securing the top of the control
panel, as shown below.
No.1 screws
Figure 4-3. Removing the Control Panel
3. Pry up the top of the control panel to separate it from the metal
frame, as shown above.
Carriage lock
lever
Pry up here after
removing screws
40