Disassembly/Reassembly Procedures - Epson L565 Service Manual

Color

Hide thumbs Also See for L565:

User manual (268 pages)

Start here (4 pages)

Start here (4 pages)

Table Of Contents

Table of Contents

L565/L566 Series

2.2 Disassembly/Reassembly Procedures

This section describes procedures for disassembling the parts/units in a flowchart format. For some parts/units,

detailed procedures or precautions are provided (accordingly indicated by icons and cell's color). Refer to the

explanations in the example chart below and perform an appropriate disassembling and assembling procedure.

(See

"2.3 Detailed Disassembly/Reassembly Procedure for each Part/Unit

For routing cables, see

The example below shows how to see the charts on the following pages.

The name enclosed in gray

indicate a part/unit that

must be removed on the

way to the target parts.

Shows necessary

procedures before

removing the following

parts.*

Black letters indicate a part/

unit not supplied as an ASP.

Parts/unit name

Disassembly/Reassembly

"2.4 Routing FFCs/cables

CR Timing Belt

FFC/ Cable

Shows removal/installation

as a unit/assy. is available.

Note "*": The box with only part names means the removal of the parts. If the name of FFC

Item

White-letter

Part/unit supplied as an ASP

Black-letter

Part/unit not supplied as an ASP

Indicates a practice or condition that could result in

injury or loss of life if not strictly observed.

Indicates a practice or condition that could result in

damage to, or destruction of equipment if not strictly

observed.

Indicates the parts that are inevitably broken in the

disassembling procedure, and should be replaced with

a new one for reassembly.

Indicates the parts that may cause the ink spill when

they are removed.

Indicates necessary check items in the disassembling/

assembling procedure.

Icon

Indicates supplementary explanation for disassembly

is given.

Indicates particular tasks to keep quality of the units

are required.

Indicates particular routing of cables is required.

Indicates particular adjustment(s) is/are required.

Indicates lubrication is required.

Indicates the number of screws securing the parts/

units.

Indicates the points secured with other than a screw

such as a hook, rib, dowel or the like.

Disassembly/Reassembly Procedures

(p53)".

Paper Guide

Upper Assy (p29)

Frame Base Assy

---

(p21)

(p27)

or a cable is shown, disconnect the FFC or cable from the connector.

Description

(p44)".)

Shows the procedure

number on the "FFC/

cable list".

White letters indicate a

Housing Rear

part/unit supplied as an

ASP.

Shows the screw types and

the specified torque on the

"Screw type/torque list".

(p22)

(p43)

Reference page

Reference