Asf Disassembly (Epson Stylus Photo 870) - Epson Stylus Photo 870 Service Manual

EPSON Stylus Photo 870/1270
Hole in the
middle frame
Combination gear 14, 28
Figure 4-35. Installing the ASF Assembly
"
Install the ASF fixing screw on the right side of the ASF
R E A S S E M B L Y
assembly (as viewed from the back); install the No.7
screw on the left side (see Figure 4-32).
"
Make sure to hook the ASF home position sensor and
paper feed motor cables on the cable hook on the right
side of the ASF assembly (as viewed from the back), as
shown below.
Place the ASF HP sensor and
PF motor cables in the hook
Figure 4-36. Hooking the ASF Home Position Sensor and
Paper Feed Motor Cables

4.2.11 ASF Disassembly (EPSON Stylus Photo 870)

NOTE: These steps are for the EPSON Stylus Photo 870 only.
Gear 32
1. Remove the auto sheet feeder as described in
Pin on the ASF
2. Using a small screwdriver, release the hook securing gear 32 to
3. Slide the right hopper release cam (white plastic) off the drive
4. Slide the left paper guide to the center of the drive shaft.
5. Unclip the white plastic spacer clipped around the drive shaft next
Chapter 4 Disassembly and Assembly
For the EPSON Stylus Photo 1270, see
Disassembly (EPSON Stylus Photo 1270)"
Assembly" on page 53.
the right side of the drive shaft and remove the gear.
Gear 32
Figure 4-37. Removing Gear 32
shaft.
to the left hopper release cam, as shown below.
"ASF
on page 58.
"Removing the ASF
Hook
54