Storing The Id Code; Programming The Id Code - Ricoh FAX2900L Operator's Manual

G3 OWN NO.
0111212-5551234kkkkk
Note
The format of the number must
be as follows: International Dial
Prefix, Your Country Code,
Your Area Code, then you must
add a Pause, followed by your
telephone number.
Check the International Dialing
Prefix and the Country Code
with your local telecommunica-
tions operator. The example
shown is for the United States;
the codes to add are 011 and 1.
Use the Pause key to add a
pause.
C
Press the {Yes} and {Function}
keys.

Storing the ID Code

In addition to the networking fea-
tures described in this section, ID
Codes are used with the following
communication features. The same
code must be used by all members of
your fax network and all people you
wish to communicate with using
these features.
• Calling to Request a Message (Poll-
ing): see P.101 "Calling to Request a
Message (Polling)".
• Closed Network: see P.74 "Closed
Network (Reception)".
Limitation
Before programming the ID Code,
confer with other users in your fax
network to agree on an ID Code.
This is because communications
using ID Codes will fail if the codes
are not the same.
KPAD/Y/N

Programming the ID Code

To store an ID Code, do the following.
A
B
C
D
E
Transfer Request (Function 13)
Features using ID Codes can only
be used between terminals made
by the same maker.
Note
The ID Code can be any four-digit
code (using digits 0 to 9 and letters
A to F), except 0000 and FFFF.
Press the {Function} {6} then enter
the access code {2} {2} {2} {2}.
Then press {6} {1} and the {Yes}
key.
SET G3 OWN NUMBER
Press V until the display appears.
SET POLLING ID
Press the {Yes} key.
POLLING ID
kkkk
Input the ID Code that you will
be using.
POLLING ID
4363
Note
Example: {4} {3} {6} {3}
Do not use 0000 or FFFF.
Press the {Yes} and {Function}
keys.
5
Y/NEXTi
Y/NEXTi
KPAD
Y/N
61