Multi-Step Transfer - Ricoh FAX2900L Operator's Manual

Multi-step Transfer

The principles of the Two-step Transfer feature can be used to build up a multi-
step facsimile network. This will using either analog (Group3) or digital
(Group4) lines. An example follows.
To set up this network, the following programming must be done.
• Terminal C must contain two preprogrammed groups. Group 1 must contain
terminal I and J, Group 2 must contain terminals E, F, G, and H. In Group 1,
terminal D must be specified as the Group Transfer Station.
• Terminal B must contain a preprogrammed group (Group 1). This group
must contain two numbers, #**01, and #**02. These specify transfer using
groups 1 and 2 that are stored in the Group Transfer Station. In Group 1, C
must be specified as the Group Transfer Station.
• The ID codes of terminal A, B, C, and D must be the same.
To start the operation, terminal A does a transfer request using terminal B as the
broadcasters stored in Group 1 at terminal B.
Transfer Request (Function 13)
5
65