Options For Polling Transmission - Ricoh FAX2900L Operator's Manual

Note
Example: {2} {5} {6} {7} from
the ten key pad.
If you see
ALREADY INPUT
already have a message on Se-
cured Polling standby.
• To erase the old message:
Clear the old polling file by
Function 23 (See P.106 "Can-
celing a Polling Transmission
(Function 23)".)
• To keep the old message, re-
peat from the step C.
F
Press the {Yes} key.
POLLING TRANS
PUSH START
G
Press the {Start} key.
Your fax message is stored and
held on polling standby.
Note
If you need to cancel a polling
transmission
Function 23 (see P.106 "Cance-
ling a Polling Transmission (Func-
tion 23)").
Options for Polling
Transmission
When you store a document in mem-
ory for Polling Transmission, you
also have the following options:
• Personal Code: This is the same as
for normal transmission (see P.27
"Personal Codes").
• Page Count: This is the same as for
normal transmission
"Printing the Page Number (Page
Count)").
Leaving a Document to Be Picked up by Others (Polling Transmission)
you
OPTi
operation, use
(seeP.25
• TTI On/Off: This is the same as for
normal transmission
"Sending Your Identification at the
Top of Your Message (TTI)" ).
• Polling Standby Duration: There
are two options (See user parame-
ters, switch 11, bit 7 P.162 "User Pa-
rameters").
• : The message will be auto-
ONCE
matically erased from memory
after it has been polled once.
• : The message will be kept
KEEP
in memory until you erase it
yourself using the user parame-
ter of the Function 63. While the
message is in the memory, it can
be polled at any time by as
many terminals that need it.
The options are only available if the
OPT V can be seen in the top right
corner of the display:
A
Press V.
SET OPTION
SET PERSONAL CODE?
B
Scroll through the options using
the V arrow on the scroll key, then
the {Yes} key.
SET OPTION
TTI PRINT?
Note
Example: TTI on/off
The list of available options is as
follows:
• Personal Code
• Page Count
• TTI
(seeP.26
5
Y/i
Y/i
105