Initial Settings (Function 61) - Ricoh FAX2900L Operator's Manual

Installation
programmed. Further, the TTI
code and the date and time of
transmission must be included in
the header of all pages faxed to,
from, or within the United States.

Initial Settings (Function 61)

During the course of this procedure
you'll have to enter letters and other
characters.
Use the ten key pad for entering num-
bers. Use Quick Dial keys 1 to 26 for
entering letters, {Yes} key to accept a
character, and Quick Dial key 27 to
enter spaces and Quick Dial key 28 to
enter symbols. See P.172 "Entering
Characters" for details.
If these settings have been made be-
fore, the messages on the display will
not always match those shown here.
The setting already entered will ap-
pear along with the word
this case, press the {Yes} key to
change the setting.
A
Press the {Function} {6} then enter
the access code {2} {2} {2} {2}.
Then press {6} {1} and the {Yes}
key.
SET G3 OWN NUMBER
10
B
Press the {Yes} key.
G3 OWN NO.
kkkkkkkkkkkkkkkkkkkk
C
Enter your phone number.
G3 OWN NO.
0111212-5551234kkkkk
208
D
. In
CHANGE?
E
Y/NEXTi
F
KPAD
G
KPAD/Y/N
Note
The format of the number is
normally as follows: Interna-
tional Dial Prefix, Your Country
Code, Your Area Code, then
you must add a Pause, followed
by your telephone number.
Check the International Dialing
Prefix and the Country Code
with your local telecommunica-
tions operator. The example
shown is for the United States;
the codes to add are 011 and 1.
Press the {Yes} key.
will flash on the dis-
PROGRAMMED
play and you'll get the display.
Note
If the machine not set up to be-
hind a PABX (see P.162 "User
Parameters"), the display for
stepH.
PABX OWN NUMBER
Press the {Yes} key.
PABX OWN NO.
kkkkkkkkkkkkkkkk
Enter the digits in the following
order : exclusive access number,
department number, pause, ex-
tension number.
PABX OWN NO.KPAD/Y/N
8123456
Press the {Yes} key.
will flash on the dis-
PROGRAMMED
play and you'll get the display.
Y/NEXTi
KPAD