Table of Contents
Advertisement
Troubleshooting
If Run LED shows...
5 flashes per second
5 flashes per second
To restore factory defaults
CAUTION This erases all archived information and user-configuration settings. You will have to reconfigure
all custom settings. It is recommended to restore the factory defaults only under the guidance of Carrier Control
Systems Support.
To erase volatile memory data and restore factory default configuration settings:
1
Turn off the MPC Open XP's power switch.
Make sure the address switches are not set to 0, 0.
2
Hold down the controller's Format button while you turn its power on.
3
Continue to hold down the Format button until the controller displays 8 and then the chase pattern, then
release the button.
4
Turn on the MPC Open XP's power switch.
To get the serial number
If you need the MPC Open XP's serial number when troubleshooting, the number is on:
•
a sticker on the back of the main controller board
•
a Module Status report (Modstat) under Core (or Main) board hardware
To obtain a modstat in the i-Vu® interface:
1
Select the MPC Open XP in the navigation tree.
2
Right-click and select Module Status.
MPC Open XP
MPC Open XPIO48/816
Installation and Start-up Guide
And Error LED shows...
2 flashes per second
On
30
Status is..
Boot is running or driver is updating
Fatal error. Replace expander or return for repair.
CARRIER CORPORATION ©2019
All rights reserved
Advertisement
Table of Contents
