When Other Messages Appear - Ricoh IM 550 Series User Manual

9. Troubleshooting

When Other Messages Appear

• When confirming or changing the settings in [Settings], press [Home] (
Message
"Administrator
Authentication for User
Management must be set
to on before this selection
can be made."
"Destination list / machine
settings are updated.
Selected destinations or
function settings have
been cleared. Please re-
select the settings."
"Cannot connect with the
wireless card. Turn the
main power switch off,
then check the card."
(A "wireless LAN board" is
referred to as a "wireless
card".)
276
Cause
The User When specifying Basic, Windows, or LDAP
Management authentication, configure the User Management
privilege is privilege in [Settings]
disabled in the Settings]
administrator Tools] tab
authentication Management].
management.
See "Registering Administrators Before Using the
Machine", User Guide (Full Version).
A destination is Wait until the message disappears and do not turn
being registered off the power of the machine. You may not be able
and devices are to perform operations for a while depending on the
being configured number of destinations being registered.
using Web Image
Monitor.
• The wireless Turn off the power, and then check the wireless
LAN board LAN board is inserted correctly. After this, turn on
was not the power again. If the message appears again,
inserted consult your service representative.
when the
machine was
turned on.
• The wireless
LAN board
was pulled
out after the
machine was
turned on.
The settings are
not updated
although the unit is
detected.
) after closing [Settings].
Solution and reference
[Machine Features
[System Settings] [Administrator
[Administrator Authentication