When Other Messages Appear - Ricoh MP 3554G User Manual

When Other Messages Appear

Message
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
(A "wireless LAN board" or
"Bluetooth interface unit" is
referred to as a "wireless
card".)
"Cannot connect with the
Bluetooth interface. Check
the Bluetooth interface."
"Clean the scanning glass.
(Located next to the
exposure glass.)"
"Following output tray is full.
Remove paper."
Cause
• The wireless LAN
board was not inserted
when the machine was
turned on.
• The wireless LAN
board was pulled out
after the machine was
turned on.
• The settings are not
updated although the
unit is detected.
• The Bluetooth interface
unit was installed while
the machine was turned
on.
• The Bluetooth interface
unit was removed while
the machine was turned
on.
The scanning glass or guide
plate of the ADF is dirty.
The output tray is full.
When Other Messages Appear
Solution
Turn off the power, and then check the
wireless LAN board is inserted
correctly. After this, turn on the power
again. If the message appears again,
contact your service representative.
Turn off the power, and then confirm
that the Bluetooth interface unit was
installed correctly. After this, turn on the
power again. If the message appears
again, contact your service
representative.
Clean the scanning glass or guide
plate. See "Maintaining Your
Machine", Maintenance and
Specifications.
Remove paper from the output tray to
resume printing. If paper is delivered to
the finisher shift tray and you want to
prevent paper from falling off the tray,
press the [Stop] key to suspend
printing, and then remove the paper.
Press [Continue] on the display panel
to resume printing.
241