Connecting The Usb, Ethernet And Com Cables - Advantech DLoG DLT-V72 Series User Manual

13.3.5. Connecting the USB, Ethernet and COM cables

Procedure as described for the power supply cable:
1. Connect the cable.
2. Open the round cable passage in the rubber seal.
3. Insert the cable.
4. Insert both components into the cable passage.
5. Secure using cable clip and screws to the strain relief rail.
NOTICE
DLT-V72 Series User Manual V2.70
Prevent system malfunction and property damage
Observe the following when connecting/removing external devices
on the DLT-V72.
1. Only use accessories that have been tested and approved for
the respective DLT-V72.
2. The DLT-V72 may not be connected to the power supply if
external devices are being connected/removed (not applicable
for USB devices)
3. Otherwise considerable damage could be caused to both the
DLT-V72 and the peripheral devices.
4. Make sure that peripherals with their own power supply are
either switched on at the same time as the DLT-V72 or after the
start of the DLT-V72.
5. Otherwise, you must ensure that a backflow from the external
device to the DLT-V72 cannot take place.
6. Only power up the DLT-V72 when all devices have been
connected and the DLT-V72 has been closed correctly
(remember the cable cover!). Otherwise, you may damage the
DLT-V72.
143 / 173
Electrical Installation