Serial Interface (Com1~Com2); Rs-232 Interface (Com 1); Automatic Data Flow Control Function For Rs-485; Lan: Ethernet Connector - Advantech UNO-1372GH User Manual

Embedded automation computer with intel atom quad-core processor, 3 x gbe, 2 x mpcie, 1 msata, 2xcom, 8xdio, 3xusb, hdmi/vga
Hide thumbs Also See for UNO-1372GH:
Table of Contents

Advertisement

2.2

Serial Interface (COM1~COM2)

The UNO-1372G offers one standard RS-232 and RS-422/485 (with cable) serial
communication inter-face ports: COM1 ~ COM2.
The IRQ and I/O address range are listed below:
COM1: 3F8h, IRQ4
COM2: 2F8h, IRQ3
2.2.1

RS-232 Interface (COM 1)

The UNO-1372G offers one RS-232 serial communication interface ports: COM1.
Please refer to Appendix A.3 for their pin assignments.
2.2.2

Automatic Data Flow Control Function for RS-485

In RS-485 mode, the UNO-1372G automatically detects the direction of incoming
data and switches its transmission direction accordingly. So no handshaking signal
(e.g. RTS signal) is necessary. This lets you conveniently build an RS-485 network
with just two wires. More importantly, application software previously written for half
duplex RS-232 environments can be maintained without modification.
2.3

LAN: Ethernet Connector

The UNO-1372G is equipped with three Gigabit LAN controller. The controller chip
used is the Intel Ethernet controller with that is fully compliant with 802.1Qav,
IEEE1588/802.1AS, 802.3az standards. The Ethernet port provides standard RJ-45
jacks on the front I/O and LED indicators in front of the connector to show its status of
Link (100Mbps orange LED, 1000Mbps green LED) and Active (flashing green LED)
status.
2.4

Power Connector

The UNO-1372G comes with a Phoenix connector that carries 9~36 V
power input, and features reversed wiring protection.Therefore, it will not cause any
damage to the system by reversed wiring of ground line and power line. Refer to
Appendix A
2.5

USB Connector

The USB interface supports Plug and Play, which enables you to connect or discon-
nect a device, without turning off the computer. This provides three USB connectors ,
which gives complete Plug & Play and hot swapping for up to 127 external devices.
One of the three connectors are compatible with USB3.0 devices. The USB interface
is USB EHCI, Rev. 2.0 compliant. The USB interface can be disabled in the system
BIOS setup. Refer to Appendix A for its pin assignment.
2.6

Display Connector

The UNO-1372G provides a HDMI and VGA controller for a high resolution interface.
It supports up to full HD resolution for two independent display.
1 x VGA, supports 1920 x 1200 @ 60Hz 24bpp
1 x HDMI 1.4a, supports 1920 x 1080 @ 60Hz 24bpp
UNO-1372G User Manual
8
external
DC

Advertisement

Table of Contents
loading

Table of Contents