Advantech DLoG DLT-V72 Series User Manual page 108

Roam section
Signal Level
The client decides to roam only when the current signal strength is weaker
than the setting value and the new visible access point has higher signal
(dBm):
strength (defined in Roam RSSI Difference).Possible values: -55 dBm to -
80 dBm
Default value: -65 dBm (adjustable in 5 dBm increments)
Minimum
This setting defines how long the client is to remain connected to the
current access point before roaming to the new access point starts.
Connection
Possible values: 5 to 25 seconds
Time (sec)
Default value: 10 seconds
Logging This setting can be used to define that the activities of the driver are
recorded in a log. Two levels are available: Critical and All.
Enable
Critical: If the debug level is set to Critical, only the critical messages
Level
from the driver will be recorded.
All: If the debug level is set to All, all messages from the driver will be
recorded.
The log file is saved in the C:\WlanLogs folder and a current timestamp is
added.
If the log file is larger than 100 mb, a new file is created.
NOTE: This option should only be enabled for short periods for analysis
purposes, not permanently!
Firmware Option can be enabled to create a "Firmware" log.
Logging The log file is saved to the C:\WlanLogs folder and is assigned the
current timestamp and the extension _fw.
If the log file is larger than 100 mb, a new file is created.
NOTE: This option should only be enabled for short periods for analysis
purposes, not permanently!
Roam RSSI The client will not connect to the new access point until the defined RSSI
difference between the new visible access point and the currently
Difference
connected access point is reached. Proper difference could avoid
(dBm)
unnecessary roaming frequency.
Possible values: 5 dBm to 25 dBm
Default value: 5 dBm
DLT-V72 Series User Manual V2.70 108 / 173
WLAN Configuration