Beckhoff EL6731 Documentation page 128

Parameterization and commissioning
Error code Meaning
0x214E DPV1-C2-Read: MSAC_C2 is not activated
0x214F DPV1-C2-Write: MSAC_C2 is not activated
0x2150 DPV1-C2-DataTransport: MSAC_C2 is not activated
0x2151 DPV1-C2-Read: FDL fault (no response etc.)
0x2152 DPV1-C2-Read: connection aborted
0x2153 DPV1-C2-Read: DPV1 fault (4 bytes error code in the diagnostic data of the slave)
0x2154 PKW-ReadNoOfElements: length must equal 1
0x2155 PKW-ReadNoOfElements: PKW is not activated
0x2156 PKW-ReadNoOfElements: axis number is too great
0x2157 PKW-ReadNoOfElements: slave not in data exchange
0x2158 PKW-ReadNoOfElements: unknown AK received (6 or 7 expected)
0x215A DPV1-C2-Write: FDL fault (no response etc.)
0x215B DPV1-C2-Write: connection aborted
0x215C DPV1-C2-Write: DPV1 fault (4 bytes error code in the diagnostic data of the slave)
0x215D DPV1-C2-DataTransport: FDL fault (no response etc.)
0x215E DPV1-C2-DataTransport: connection aborted
0x215F DPV1-C2-DataTransport: DPV1 fault (4 bytes error code in the diagnostic data of the slave)
0x2163 DPV1-C2-DataTransport: Incorrect IndexOffset
0x2600-0x26F AK 7 (error) during PKW processing, error code in low byte
F
0x2700-0x27F Fault during DPV1 processing, 4 bytes error code in the slave diagnostic data, byte 3 of the error code (error class) is in
F Low byte
"Not expected" error codes from the PROFIBUS slave in 0x28xx
Error code Meaning
0x0 OK (is usually not passed on by the terminal)
0x1 UE = User Error
0x2 RR = No resources
0x3 RS = SAP not enabled
0x8*** DL = Data Low (normal case with DP)
0x9*** NR = No response data ready
0xA DH = Data High (DP diagnosis pending)
0xC RDL = Data not received and Data Low
0xD RDH = Data not received and Data High
***)
DL and NR are handled by the EL6731
128 Version: 2.8 EL6731