Drilling, Centering - Cycle82 - Siemens SINUMERIK 802D Training Manual

Section 4

Drilling, centering - CYCLE82

Programming
CYCLE82(RTP, RFP, SDIS, DP, DRP, DTB)
Parameters
RTP
RFP
SDIS
DP
DPR
DTB
These six parameters are used through out all the drilling cycles, but as
more functionality is required as are the number of parameters increased.
If you look below, as you cursor down the parameter windows you will get
a prompt with text, which relates to the picture guide.
SINUMERIK 802D sl Operating and Service Training Manual
Drilling cycles
retraction plane (absolute)
reference plane (absolute)
safety plane (enter without sign)
final drilling depth (absolute)
final drilling depth relative to the reference plane
(enter without sign)
dwell time at final depth (chip breaking)
Page 12
Notes
C99
C99