Configure Ddns; Configure Pppoe - HIKVISION DS-7716NXI-I4/16P/4S User Manual

DS-77xxNXI-I4/16P/4S NVR User Manual
Hik-Connect Mobile Client
Refer to the help file on the official Website (www.hik-connect.com) and the
User Manual
for adding the device to Hik-Connect and more operating instructions.

16.3 Configure DDNS

Purpose
You can set Dynamic DNS service for network access. Modes available: DynDNS, PeanutHull, and NO-IP.
Before You Start
You must register DynDNS, PeanutHull, and NO-IP services with your ISP before configuring DDNS settings.
1. Go to System > Network > TCP/IP > DDNS.
2. Check Enable.
3. Select DynDNS under DDNS Type.
PeanutHull and NO-IP are also available under DDNS Type. Enter required information accordingly.
4. Enter Server Address for DynDNS (i.e., members.dyndns.org).
5. Under Device Domain Name, enter the domain name obtained from the DynDNS Website.
6. Enter the User Name and Password registered in the DynDNS Website.
Figure 16-7 DDNS Settings
7. Click Apply.

16.4 Configure PPPoE

If the device is connected to the Internet through PPPoE, you need to configure a user name and
password accordingly under System > Network > TCP/IP > PPPoE.
UM DS-77xxNXI-I4/16P/4S 050619NA 146