Chapter 16 Network Settings; Configure Tcp/Ip Settings - HIKVISION DS-7716NXI-I4/16P/4S User Manual

DS-77xxNXI-I4/16P/4S NVR User Manual

Chapter 16 Network Settings

16.1 Configure TCP/IP Settings

Purpose
TCP/IP settings must be properly configured before you can operate the device over a network.
1. Go to System > Network > TCP/IP.
2. Select Net-Fault Tolerance or Multi-Address Mode under Working Mode.
•
Net-Fault Tolerance: The two NIC cards use the same IP address, and you can set the main NIC to LAN1
or LAN2. In this way, if one NIC card fails, the device will automatically enable the other standby NIC
card to ensure normal running of the system.
•
Load Balance: The two NIC cards use the same IP address and share the total bandwidth load, which
enables the system to provide two Gigabit network capacity.
•
Multi-Address Mode: The two NIC card parameters can be configured independently. Select LAN1 or
LAN2 under Select NIC for parameter settings. You can select one NIC card as the default route, and
then for the system connecting with the extranet, the data will be forwarded through the default
route.
3. Configure other IP settings as needed.
Check Enable DHCP to obtain IP settings automatically if a DHCP server is available in the network.
Valid range of MTU value is 500 to 9676.
UM DS-77xxNXI-I4/16P/4S 050619NA
Figure 16-1 TCP/IP Settings
143