Ir Remote Control Operations; Pairing (Enabling) The Ir Remote To A Specific Device (Optional); Unpairing (Disabling) Ir Remote From Device - HIKVISION DS-7716NXI-I4/16P/4S User Manual

DS-77xxNXI-I4/16P/4S NVR User Manual

1.3 IR Remote Control Operations

The device may also be controlled with the included IR remote control, shown in Figure 1-2.
Batteries (2 × AAA) must be installed before operation.
The IR remote is set at the factory to control the device (using default Device ID# 255) without any
additional steps. Device ID# 255 is the default universal device identification number shared by the
devices. You may also pair an IR Remote to a specific device by changing the Device ID#, as follows:

1.3.1 Pairing (Enabling) the IR Remote to a Specific Device (optional)

You can pair an IR Remote to a specific device by creating a
user-defined Device ID#. This feature is useful when using
multiple IR Remotes and devices.
On the device:
1. Go to System > General.
2. Type a number (255 digits maximum) into the Device No. field.
3. On the IR Remote: Press the DEV button.
4. Use the Number buttons to enter the Device ID# that was
entered into the device.
5. Press Enter button to accept the new Device ID#.

1.3.2 Unpairing (Disabling) IR Remote from Device

To unpair an IR Remote from a device so that the unit cannot
control any device functions, press the DEV key on the IR Remote.
Any existing Device ID# will be erased from the unit's memory and
it will no longer function with the device.
Figure 1-2 Remote Control
(Re)-enabling the IR Remote requires pairing to a device. See
"Pairing the IR Remote to a Specific device (optional)," above.
The keys on the remote control closely resemble the ones on the
front panel. See table 1.4.
UM DS-77xxNXI-I4/16P/4S 050619NA 27