Steer Sensor - Raven SBGuidance Auto Installation Manual

Press 'Connect' to establish communication with the
hydraulic valve (Figure 21).
If there is communication, information about the valve
will show up in the module (Figure 21).

Steer sensor

To make the system work properly the values of the
wheel angle sensor has to be checked and possibly
changed. Three wheel angle sensor values are
necessary; position completely left, right and centre.
Open the tab 'Sensor'. Press 'Get parameters', wait 5
seconds and press 'refresh'. After pressing these
buttons, all parameters are shown in the tab (Figure
23).
Left value =
Centre value =
Right value =
To check these values, open the tab 'Status' and press
'Enable status set no. 1'.
The value which is visible behind 'AD1:' is the value of
the steer sensor (see Figure 24).
Turn the wheels completely to the left and read the
value. Compare this value with the value in the tab
'Sensor' (AD1_1000_Left).
Pag 28/33 I SBG-Claas ATP Ready-IM-EN- Rev. A
AD1_1000_Left
AD1_1000_Neutral
AD1_1000_Right
SBGuidance Auto I Rev. A I Claas ATP Ready
Figure 21 Information about the valve.
Figure 23 Values steer sensor.
Figure 24 Steering sensor value.