Mounting Dynamiq Iso/Iso Steering Controller - Raven SBGuidance Auto Installation Manual

SBGuidance Auto I Rev. A I Claas ATP Ready
5. Mounting DynamIQ ISO/ISO
Steering Controller
The following guidelines have been established for
mounting the DynamIQ ISO/ISO Steering Controller:
Preferably, place the DynamIQ ISO/ISO
•
Steering Controller next to and at the right side
of the seat. Use the standard DynamIQ ISO/ISO
Steering Controller mounting plate (Figure 15).
• If it is not possible to attach the DynamIQ
ISO/ISO Steering Controller to the seat bolts,
the DynamIQ ISO/ISO Steering Controller
should be attached in an appropriate place in
the cabin that is free from vibrations.
A DynamIQ ISO/ISO Steering Controller may
•
only be mounted in a horizontal position (with
the sticker side up). The connectors may be
orientated in four directions (0, 90, 180, 270
degrees).
By default, the orientation of the DynamIQ
•
ISO/ISO Steering Controller is set to: horizontal
position with connectors pointing towards the
rear (as shown in Figure 15). Any other
orientation should be set in the software!
Figure 15 ISO Steering Controller on a
mounting plate.
Pag 23/33 I SBG-Claas ATP Ready-IM-EN-Rev. A