Mounting Gps- And Radio/Gsm- Antenna; Mounting The Standard Gps Antenna Bracket - Raven SBGuidance Auto Installation Manual

SBGuidance Auto I Rev. A I Claas ATP Ready
4. Mounting GPS- and
radio/gsm- antenna
A standard GPS bracket can be mounted on a Claas
ATP Ready tractor.
4.1. Mounting the standard GPS antenna
bracket
Figure 7 shows an example of a standard GPS-antenna
(with a Laird antenna in this case) mounted on a
standard GPS-antenna bracket. A GPS-dummy and a
UNC bolt + nut are also mounted. The standard GPS-
antenna bracket can be mounted with double sided
tape on the cabin roof.
For mounting a GPS-antenna a few general
instructions are applicable:
Mount the GPS-antenna at least 60 cm in front
•
of the rear axle.
Mount the GPS-antenna in the middle of the
•
tractor.
Mount the GPS-antenna on the supplied UNC
•
bolt.
Mount the TNC-dummy on the GPS-antenna
•
bracket (Figure 7).
• Wire the antenna cable connector with the
largest connector through to the inside of the
cabin.
Fasten the antenna cable so that it cannot
•
become pinched anywhere and conceal inside
the cabin upholstery, together with the GPS
patch antenna cable, radio antenna cable or
UMTS antenna cable.
Mount the GPS antenna cables in a way water
•
cannot flow down into the cabin.
Mount the antenna cable in such a way that no
•
water is allowed to flow along the cable into the
cabin.
Label the antenna cable inside the cabin with
•
label 'GPS1'.
Figure 7 Standard GPS antenna bracket + UNC bolt
and nut mounted on a Claas roof.
Pag 17/33 I SBG-Claas ATP Ready-IM-EN-Rev. A