Calibration Mode - Raven SBGuidance Auto Installation Manual

SBGuidance Auto I Rev. A I Claas ATP Ready
If the value is not correct, open the tab 'Parameters'
(Figure 25) to change the value. Search the value,
double-click on it and it will be shown in the bar (see
red rectangle in Figure 25). Overwrite the old value
with the correct value and press 'Set'.
Do the same for the centre- and right value. After
changing any of these values press 'Commit'.
Please note!:
If any value has changed, press 'Commit' before
proceed further.

Calibration mode

The hydraulic valve has two modes, the Operation
mode and the Calibration mode. In calibration mode it
is possible to calibrate these values. Open the tab
'MMI' (Figure 26) and press the button 'enter
calibration mode'. To get in the calibration mode, the
Valve needs to be powered off and on again. To switch
the valve off and on use the switch which is visualized
in Figure 17. Follow the steps to get in the Calibration
mode. In the lower left corner, the mode is shown
(Figure 26).
When the valve is in Calibration mode, press 'Start
valve auto-cal.'. Do not touch the steering wheel while
calibrating! At ''Status'' the progress will be shown.
Sometimes you have to press multiple times on ''start
valve auto-cal.'' Once the calibration has started wait
until ''Auto-calibration completed'' is shown behind
Status. Some parameters won't be saved when the
valve auto calibration is not executed.
Please note!:
If you want to edit the minimum or maximum
steering percentage parameters you have to do
Figure 25 Tab parameters.
Figure 26 Calibration mode.
Pag 29/33 I SBG-Claas ATP Ready-IM-EN-Rev. A