Mounting Harness; Mount Harness - Raven SBGuidance Auto Installation Manual

SBGuidance Auto I Rev. A I Claas ATP Ready

3. Mounting harness

Two options can be chosen, a CAN Basic harness or an
Implement Ready (IR) harness.
3.1. CAN Basic harness
The Basic harness can only be used for tractor steering. If
the tractor is mounted with this harness there is no
possibility to use the tractor for implement steering (TWIN,
plough).
3.2. CAN Implement Ready (IR) harness
The Implement Ready harness ensures that the tractor can
be used for tractor and implement steering. Mounting the
implement is possible through the IBBC-connector. The
harness is mounted from the battery to the IBBC-connector
at the back side of the tractor.

3.3. Mount harness

The CAN basic harness and the CAN Implement
harness are divided in the following harnesses (ranked
in order from the battery):
1. Power harness: this harness comes from the
battery and goes to the rear axle along the chassis,
wrapped in a hard casing. A Basic harness goes
from the battery directly to the chassis harness
(and not to the rear axle of the tractor). Mount the
relays and fuses well nearby the battery. Find a
place where they can be fastened firmly and
vibration free (Figure 2).
2. Extension harness: extends the power harness to
the In-Cab harness. This harness is wrapped in a
hard casing. This harness goes inside the cabin.
Figure 2 Correctly mounted relays and fuses.
Pag 13/33 I SBG-Claas ATP Ready-IM-EN-Rev. A