Table of Contents
Advertisement
chipDISK for RemoteView
Ê Close the server again (see chapter "Opening and closing the server" on
page 47).
Removing is done in the reverse order.
8.2.2
Configuring chipDISK
In order for RemoteView to be started automatically, you will first need to enter
the hard disk drive parameters in BIOS Setup and, using these parameters,
boot from the hard disk drive. Proceed as follows:
Ê Start the server.
Ê Press [F2] when the message Press <F2> to enter SETUP is displayed on the
screen.
Ê Select the menu item IDE Drive 1 from the Main screen page in the BIOS
Setup.
Ê Set the value Type to USER with the following CHS parameters:
Cylinder: 490; Head: 2; Sectors: 32.
Ê Select the menu item Server from the BIOS Setup.
Ê Set the value for Diagnostic System to enabled. Then set the entry for Next Boot
Uses to Diagnostic System.
Ê Save the settings, and exit the BIOS Setup.
The server boots MS-DOS and RemoteView from the chipDISK.
Further information is provided in the technical manual for the system board or
in the documentation for the BIOS Setup (see "Related publications" on
page 131).
I
If the RemoteView software is not yet installed on the chipDISK, install the
software as described in the manual for RemoteView.
Ê To terminate RemoteView, use the menu item Boot Original OS.
The server boots the standard operating system. How to operate RemoteView is
described in the manual for RemoteView.
74
System components and expansions
U41147-J-Z156-2-76
Advertisement
Table of Contents
